
Analisis Struktur Baja Pada Gedung FKIP Universitas Borneo Tarakan Dengan Metode LRFD (Load Resist Factor Design)
Pengarang : Mochammad Iqbal - Personal Name;
Perpustakaan UBT : Universitas Borneo Tarakan., 2018XML Detail Export Citation
Abstract
Struktur baja adalah material yang banyak digunakan dalam bangunan khususnya bangunan bangunan tinggi. Namun, dibutuhkan perencanaan yang optimum agar kinerja dari bangunan tersebut dapat memenuhi standart keamanan dan kenyamanan. Metode yang digunakan dalam penyelesaian penulisan ini adalah LRFD ( Load Resistence Factor Design ) yang berdasarkan pada SNI 031729-2002 dan menganalisa dengan bantuan software STAAD Pro Versi 8 dan AFFES . Sehingga tujuan penulisan skripsi ini untuk menjelaskan bagaimana perencanaan struktur baja yang mampu menahan gaya gempa serta dapat menghitung struktur utama dari gedung berupa plat lantai, balok dan kolom serta pondasi yang didukung oleh data sondir dan boring Dari hasil penelitian diperoleh dimensi struktur sekunder berupa pelat lantai dengan rata rata tebal plat setiap lantai 120 hingga 150 mm, untuk struktur primer diperoleh dimensi balok dimana menggunakan baja WF 588.300.12.20 sedangkan kolom menggunakan WF 400.400 dan dari hasil perhitungan bahwa profil tersebut memenuhi standart keamanan dan kenyamanan. Untuk struktur bawah atau pondasi menggunakan tiang pancang dengan ukuran 50 cm x 50 cm sebanyak 4 buah setiap pondasinya dan untuk pile cap digunakan dimensi 2,25 m x 2,25 m dengan tebal 80 cm .
Steel structure is a material that is widely used in buildings, especially high-rise buildings. However, optimum planning is needed so that the performance of the building can meet the safety and comfort standards. The method used in the completion of this writing is LRFD (Load Resistence Factor Design) which is based on SNI 03-1729-2002 and analyzes with the help of STAAD Pro Version 8 and AFFES software. So the purpose of writing this thesis is to explain how steel structure planning is able to withstand earthquake forces and can calculate the main structure of the building in the form of floor plates, beams and columns as well as foundations that are supported by sondir and boring data. From the results of the study obtained the dimensions of the secondary structure in the form of slab with average plate thickness on each floor 120 to 150 mm, for the primary structure obtained dimensions of the beam which uses WF 588,300.12.20 steel while the column uses WF 400,400 and from the calculation that the profile meets the safety standard and comfort. For the bottom structure or foundation using a pile with a size of 50 cm x 50 cm as much as 4 pieces per foundation and for pile cap used dimensions 2.25 m x 2.25 m with a thickness of 80 cm.