Rancang Bangun Modul Automatic Transfer Switch (ATS) Dengan Menggunakan Programmable Logic Controller (PLC) Omron Sysmac CPM2A | ELECTRONIC THESES AND DISSERTATION
Image of Rancang Bangun Modul Automatic Transfer Switch (ATS) Dengan Menggunakan Programmable Logic Controller (PLC) Omron Sysmac CPM2A

Rancang Bangun Modul Automatic Transfer Switch (ATS) Dengan Menggunakan Programmable Logic Controller (PLC) Omron Sysmac CPM2A

Pengarang : Aprianus Siola - Personal Name;

Perpustakaan UBT : Universitas Borneo Tarakan., 2012
XML Detail Export Citation
    SKRIPSI

Abstract

Sumber listrik utama yang disalurkan dari PLN tidak selamanya hidup atau dapat men-suplai ke konsumen secara terus menerus, suatu saat pasti akan terjadi pemadaman atau adanya perbaikan pada pembangkit. Untuk mengantisipasi dari pemadaman tersebut, maka ada beberapa konsumen PLN yang melengkapi rumah atau perusahaannya dengan pembangkit listrik cadangan yaitu genset. Jika terjadi pemutusan dari suplai PLN, tentunya dibutuhkan peralatan yang berfungsi sebagai pemindah sumber tegangan dari PLN ke genset. Namun demikian
pemindah secara manual membutuhkan waktu yang relatif lebih lama. Tugas akhir ini bertujuan untuk mendesain sebuah ATS berbasis PLC atau yang berfungsi untuk memindahkan sumber tegangan secara otomatis. Dari hasil desain dan implementasi ATS diperoleh bahwa dalam kondisi PLN mati atau hidup tidak diperlukan lagi tenaga operator. Selain itu waktu proses dalam
pemindahan sumber tegangan juga lebih singkat.

The main power source which supplied from PLN not always in “on” position forever or be able to supply to customers on an ongoing basis, is bound to happen someday or a repair outage at the plant. In anticipation of these cuts, then there are some consumers PLN that complements your home or company with the backup power generators. In the event of termination of the supply PLN, of course, the equipment needed to function as a voltage source switching from electricity to the generator. However, manually transfer requires a relatively longer time. This thesis aims to design a PLC-based ATS or that serves to move the source voltage automatically. From the results of the design and implementation of the ATS found that the conditions of power failure or life energy operator is not required anymore. In addition the process in the removal of the source voltage is also shorter time.

Detail Informasi