Studi Kuat Tekan Dan Penyerapan Air Paving Block Dengan Pemanfaatan Bottom Ash Sebagai Pengganti Pasir Dan Subtitusi Fly Ash Terhadap Semen | ELECTRONIC THESES AND DISSERTATION
Image of Studi Kuat Tekan Dan Penyerapan Air Paving Block Dengan Pemanfaatan Bottom Ash Sebagai Pengganti Pasir Dan Subtitusi Fly Ash Terhadap Semen

Studi Kuat Tekan Dan Penyerapan Air Paving Block Dengan Pemanfaatan Bottom Ash Sebagai Pengganti Pasir Dan Subtitusi Fly Ash Terhadap Semen

Pengarang : Sarina - Personal Name;

Perpustakaan UBT : Universitas Borneo Tarakan., 2024
XML Detail Export Citation
    SKRIPSI

Abstract

PLTU Malinau adalah pembangkit listrik dengan bahan bakar utama batu bara, sehingga selain menghasilkan listrik PLTU juga menghasilkan limbah padat berupa fly ash dan bottom ash. Pemanfaatan limbah fly ash dan bottom ash telah banyak dilakukan terutama sebagai bahan pengganti atau subtitusi pada pembuatan paving block. Tujuan dari penelitian ini yaitu mengetahui nilai kuat tekan dan presentase penyerapan air rata-rata paving block dengan subtitusi fly ash 0%, 10%, 20%, 30% terhadap semen dan bottom ash sebagai pengganti pasir serta perbandingan campuran 1 : 3. Pada penelitian ini dibuat benda uji berbentuk balok sebanyak 120 sampel dengan pengujian kuat tekan pada umur 14 hari, 21 hari, 28 hari dan pengujian penyerapan air pada umur paving 28 hari. Berdasarkan hasil penelitian diperoleh rata-rata kuat tekan pada umur 14 hari setiap variasi secara berturut-turut yaitu 16,48 Mpa ; 13,53 Mpa ; 11,87 Mpa dan 9,51 Mpa. Pada umur 21 hari yaitu 17,55 Mpa ; 15,40 Mpa ; 13,83 Mpa dan 10,89 Mpa. Paving block dengan umur 28 hari yaitu 19,23 Mpa ; 16,18 Mpa ; 15,20 Mpa dan 13,04 Mpa. Penurunan nilai kuat tekan paving block terjadi karena semakin besarnya subtitusi fly ash. Sedangkan hasil penyerapan air rata-rata paving block setiap variasi secara berturut-turut yaitu 6,3% ; 8% ; 8,3% dan 9%. Semakin besar nilai subtitusi fly ash maka penyerapan airnya juga semakin besar


Kata Kunci : PLTU, Paving Block, Fly Ash, Bottom Ash, Kuat Tekan, Penyerapan Air

PLTU Malinau is a power plant with the main fuel, namely coal, so apart from producing electricity, PLTU also produces solid waste in the form of fly ash and bottom ash. The use of fly ash and bottom ash waste has been widely used, especially as a replacement or substitute material for making paving blocks. The purpose of this study was to determine the compressive strength value and average water absorption percentage of paving blocks with fly ash substitution of 0%, 10%, 20%, and 30% for cement and bottom ash as a substitute for sand and a mixture ratio of 1: 3. In this study 120 samples of block-shaped test objects were made with compressive strength testing at 14 days, 21 days, 28 days and water absorption testing at 28 days of paving. Based on the research results, the average compressive strength at 14 days for each variation was 16.48 Mpa; 13.53 MPa; 11.87 Mpa and 9.51 Mpa. At the age of 21 days, it was 17.55 Mpa; 15.40 MPa; 13.83 Mpa and 10.89 Mpa. Paving block with an age of 28 days, namely 19.23 Mpa; 16.18 MPa; 15.20 Mpa and 13.04 Mpa. The decrease in the compressive strength value of paving blocks occurred due to the increasing substitution of fly ash. Meanwhile, the average water absorption results for paving blocks for each variation respectively were 6.3%; 8%; 8.3% and 9%. The greater the fly ash substitution value, the greater the water absorption. Keywords: PLTU, Paving Block, Fly Ash, Bottom Ash, Compressive Strength, Water Absorption

Detail Informasi