Desain Dan Simulasi Sistem PLTS Terhubung Pompa Air Menggunakan Motor Induksi Dengan Metode PID | ELECTRONIC THESES AND DISSERTATION
Image of Desain Dan Simulasi Sistem PLTS Terhubung Pompa Air Menggunakan Motor Induksi Dengan Metode PID

Desain Dan Simulasi Sistem PLTS Terhubung Pompa Air Menggunakan Motor Induksi Dengan Metode PID

Pengarang : Nur Ifansyah - Personal Name;

Perpustakaan UBT : Universitas Borneo Tarakan., 2023
XML Detail Export Citation
    SKRIPSI


Abstract

Motor induksi tiga fasa adalah salah satu peralatan listrik yang banyak digunakan baik di industri maupun rumah tangga, salah satu aplikasinya yaitu untuk pompa air. Pada tugas akhir ini didesain dan dirancang sistem pompa air motor induksi tiga fasa dengan sumber tenaga sel surya. Intensitas radiasi matahari yang berubah-ubah sepanjang waktu mengakibatkan daya dan tegangan yang dihasilkan sel surya menjadi naik turun. Bila sel surya tersebut dihubungkan dengan beban seperti motor induksi akan mengakibatkan daya keluaran sel surya tidak optimum, sehingga menyebabkan efisiensi daya keluaran sel surya terhadap daya maksimum rendah. Untuk menjaga agar sel surya selalu menghasilkan daya yang tinggi maka diperlukan suatu kontrol MPPT (Maximum Power Point Tracking), tegangan DC-Link dapat dijaga konstan dengan tegangan 600 Volt dan dan Kontrol PID mampu mengatur kecepatan motor. Kecepatan motor yang diperoleh yaitu 1485 RPM dengan debit pompa 10 liter/detik, di intensitas cahaya matahari maksimum 1000 W/m².

Kata Kunci : PLTS, Motor Induksi, MPPT, Metode PID

A three-phase induction motor is one of the electrical equipment that is widely used both in industry and households, one of its applications is for water pumps. In this project, a three-phase induction motor water pump system with a solar cell power source was designed. The intensity of solar radiation that changed over time caused the power and voltage produced by solar cells to fluctuate. If the solar cell was connected to a load such as an induction motor, the output power of the solar cell was not optimal, causing the efficiency of the solar cell output power to the maximum power to be low. To ensure that solar cells produced high power, the MPPT (Maximum Power Point Tracking) control was needed, the DC-Link voltage was then maintained constant with a voltage of 600 Volts, and the PID (Proportional-integral-Derivative) control was able to regulate motor speed. The motor speed obtained was 1485 RPM with a pump discharge of 10 liters/second at the maximum sunlight intensity of 1000 W/m² Keywords: Solar Power Plant, Induction Motor, MPPT, PID Method

Detail Informasi