Desain Simulasi Inverter On Grid Menggunakan Current Controlled Dengan Software PSIM | ELECTRONIC THESES AND DISSERTATION
Image of Desain Simulasi Inverter On Grid Menggunakan Current Controlled Dengan Software PSIM

Desain Simulasi Inverter On Grid Menggunakan Current Controlled Dengan Software PSIM

Pengarang : Dwi Jayanto - Personal Name;

Perpustakaan UBT : Universitas Borneo Tarakan., 2020
XML Detail Export Citation
    SKRIPSI

Abstract

Penelitian ini melakukan desain simulasi inverter on grid menggunakan metode current controlled dengan software PSIM. Rangkain inverter yang digunakan adalah rangkaian inverter fullbridge dengan sistem kendali menggunakan metode current controlled. Rangkaian filter yang digunakan adalah filter low pass (LC) dengan nilai L adalah 0.0113H dan nilai C adalah 100nF. Rangkaian kendali yang digunakan adalah rangkaian SPWM (Sinusoidal Pulse Width Modulation). Keluaran arus inverter diatur sebesar 6 A (rms) dengan variasi pembebanan dan sudut fasa antara tegangan dan arus berubah. Sudut fasa antara arus dan tegangan berpengaruh terhadap daya yang disuplai inverter ke grid. Pada saat inverter memiliki sudut fasa yang sama dengan grid maka daya yang disuplai sesuai dengan referensi yang diberikan oleh sistem kontrol. Kelebihan daya dari inverter akan disuplai ke grid, begitu pula kekurangan daya akan disuplai dari grid. Pada saat arus inverter lagging 90° dari tegangan maka inverter menyuplai daya reaktif ke sistem dan memkonsumsi daya aktif dari sistem. Daya reaktif yang dikirim ke sistem jauh lebih besar dari daya aktif yang dikonsumsi oleh inverter. Pada saat arus inverter leading 90° dari tegangan maka inverter menyerap baik daya aktif maupun daya reaktif dari sistem. Frekuensi pada sistem konstan dengan nilai 50Hz.

This study conducted an on-grid inverter simulation design using the current controlled method with PSIM software. The inverter circuit used is a fullbridge inverter circuit with a control system using the current controlled method. The filter circuit used is a low pass filter (LC) with a L value of 0.0113H and a C value of 100nF. The control circuit used is the SPWM (Sinusoidal Pulse Width Modulation) circuit. The output current of the inverter is set at 6 A (rms) with variations in loading and the phase angle between voltage and current changes. The phase angle between current and voltage affects the power supplied by the inverter to the grid. When the inverter has the same phase angle as the grid, the power supplied is in accordance with the reference given by the control system. The excess power from the inverter will be supplied to the grid, as well as the lack of power will be supplied from the grid. When the inverter current is 90° lagging from the voltage, the inverter supplies reactive power to the system and consumes active power from the system. The reactive power delivered to the system is much greater than the active power consumed by the inverter. When the inverter current is leading 90° from the voltage, the inverter absorbs both active and reactive power from the system. The frequency of the system is constant with a value of 50Hz.

Detail Informasi