UPT. Perpustakaan Universitas Borneo Tarakan | ELECTRONIC THESES AND DISSERTATION
Image of Analisa Pengaruh Pengasutan Motor Induksi 3  Fasa Jenis Dahlander Dengan Hubung Seri  Paralel Berbasis Programable Logic  Controller (PLC)

Analisa Pengaruh Pengasutan Motor Induksi 3 Fasa Jenis Dahlander Dengan Hubung Seri Paralel Berbasis Programable Logic Controller (PLC)

Pengarang : Marcelo Prasetia

Perpustakaan UBT : Universitas Borneo Tarakan,2024
    SKRIPSI

Abstrak Indonesia

Motor dahlander adalah jenis motor alternating current (ac) asinkron dengan 2 putaran atau lebih. adanya dua macam belitan yang terpisah menyebabkan motor induksi 3 fasa mempunyai 2 ukuran kecepatan. hal ini akan terlihat apabila dibandingkan dengan motor induksi 3 fasa yang hanya mempunyai 1 putaran dengan daya yang sama. pada penelitian ini akan dilakukan pengasutan terhadap motor dahlander bertujuan untuk mengetahui konfigurasi pada rangkaian motor jenis dahlander menggunakan plc sehingga dapat menetukan kecepataan yang di inginkan. dari hasil pengujian motor induksi 3 fasa jenis dahlander berbasis plc konfigurasi yang digunakan yaitu seri dan paralel. pada konfigurasi didapat arus starting motor 3,19 a dan running motor 1,33 a sedangkan konfigurasi paralel arus starting motor 7,89 a dan running motor 1,89 a. konfigurasi tersebut dibandingkan dengan hubung dol hasil yang didapat arus starting motor 21,6 a dan arus running motor 11,6 a. penelitian ini mengkonfirmasi bahwasannya konfigurasi seri dan paralel lebih baik daripada konfigurasi dol. kata kunci: motor dahlander, programmable logic controller, pengasutan motor induksi.

Abstrak Indonesia

The dahlander motor is an asynchronous alternating current (ac) motor with 2 or more. the existence of two separate windings causes the motor to have 3 3-phase induction motors to have 2 sizes of speed. it can be seen when compared to a 3- phase induction motor that only has 1 rotation with the same power in this study, the starting of the dahlander motor aims to determine the configuration in the motor circuit using plc to determine the speed. the configuration was series and parallel from the test results of the plc-based dahlander type 3-phase induction motor. in the configuration obtained, the current starting motor was 3.19 a, and the running motor was 1.33 a, while in parallel configuration, the starting current of the motor was 7 89 a, and the running motor was 1.89 a. the configuration was compared with the dol circuit, and the results were obtained by the motor starting current of 21.6 a and the motor running current of 11.6 a. this research confirms that the series and parallel configurations are better than the dol configuration keywords dahlander motor, programmable logic controller, motor starting induction.